Development and performance evaluation of alkali-activated multiple solid waste-based building foam insulation materials

To reduce building environmental pollution and energy consumption has become the mainstream development trend of today's society. The building foam insulation materials (SWFIM) was developed by using blast furnace slag (BSF), waste photovoltaic glass (WPG), rice husk ash (RHA), and plant ash (PA), and the corresponding preparation technologies were proposed. The dry density, thermal conductivity, compressive strength, volumetric water absorption and pore structure parameters of SWFIM were measured. The effects of the amount of hydrogen peroxide solution (HPS), foam stabilizer (FS) and polyethylene (PE) fiber on the basic properties of SWFIM were discussed. The microscopic morphology of SWFIM was characterized by SEM (Scanning electron microscope) technology, and the mechanism of three influencing factors were revealed. The relationship between the basic properties of SWFIM was discussed and the corresponding prediction models were established. The test results showed that the effects of HPS and FS on the basic properties of SWFIM were complementary. When the amount of HPS and FS was 10 % and 1 %, respectively, SWFIM have achieved encouraging performance. PE fiber had different degrees of negative effects on the thermal properties of SWFIM, and the negative effects gradually increased with the increase of PE fiber content. The improvement effect of PE fiber on the compressive strength of SWFIM changes from positive influence to negative influence with the fiber content. When the fiber content increased to 0.6 %, the improvement effect was most obvious, increased by about 12.20 %. Statistics showed that the thermal conductivity and compressive strength of SWFIM were 0.0497 ∼ 0.0581 W/(m·K) and 0.33 ∼ 0.52 MPa, respectively. This showed that SWFIM was expected to become a potentially competitive building insulation material.